Page 2: Features Page 3 i Preface Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all Operation is subject to the following Page 6 iv Integrated Peripherals Page 7: Installing the Motherboard in a Case 1 Chapter 1 Introducing the Motherboard Introduction Thank you for choosing this motherboard of great performance and with enhanced Page 14 8 Do not over-tighten the screws as this can stress the motherboard.
|Published (Last):||26 October 2010|
|PDF File Size:||18.47 Mb|
|ePub File Size:||16.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page 7: Chapter 2: Hardware Installation degree angle. Step 3: Look for the white triangle on socket, and the gold triangle on CPU should point towards this white triangle. The CPU will fit only in the correct orientation. This completes the installation. When connecting with wires onto connectors, please note that the red wire is the positive and should be connected to pin 2, and the black wire is Ground and should be connected to GND. Page 11 C. Dual Channel Memory installation To trigger the Dual Channel function of the motherboard, the memory module must meet the following requirements: Install memory module of the same density in pair, shown in the following table.
The IDE connectors can connect a master and a slave drive, so you can connect up to four hard disk drives. This PCI slot is designated as 32 bits. Pin opened Wait for five seconds. Power on the AC. Reset your desired password or clear the CMOS data.
Fault Tolerance: No. The mirrored backup copy of the data can reside on the same disk or on a second redundant drive in the array. RAID 1 provides a hot-standby copy of data if the active volume or drive is corrupted or becomes unavailable because of a hardware failure.
Page Chapter 5: Useful Help You will see the following window after you insert the CD The setup guide will auto detect your motherboard and operating system. EXE under your optical drive. Make a bootable floppy disk.
Page 23 If the system shutdown automatically after power on system for seconds, that means the CPU protection function has been activated. When the CPU is over heated, the motherboard will shutdown automatically to avoid a damage of the CPU, and the system may not power on again. System inoperative. Keyboard lights are on, power indicator lights are lit, and hard drive is spinning.
Biostar K8M800 Micro AM2 Setup Manual
BIOSTAR K8M800 MICRO AM2 User Manual
ECS K8M800-M2 K8M800-M2 (V2.0) User Manual